 ...make your truck-dreams come true! |
|
Manual
hvg-Robbe driven rear axle
|
|
Insert
the two drive shafts into the
differential gear and secure them with the provided safety clips. |
 |
 |
Fix
the bevel gear (like shown below)
with 4 countersunk screws M2x4 !Use threadlock! |
|
Push
onto each of the two drive
shafts 2 ball bearings (6x10x3) and 2 spacers (6,2x10x3). Please respect picture shown sequence! |
 |
 |
Place
the two ball bearings (5x11x3) on the
short drive shaft. Afterwards you fasten slightly the bevel gear use set-screw M3x3 (do not tighten the set screw yet). |
|
Place
assembled differential gear and
drive shaft (like picture shown) into one of the differential housing halves. Afterwards you set up carefully the transmission unit for free and smooth running, then tighten set-screw. !Use threadlock! |
 |
 |
Do not forget to use grease to get the
differential running smooth and quiet. Insert the rubber stopper (like picture shown) into the housing. |
|
Assemble
the differential housing with |
 |
|
Care
screw holes are not on the same side.
hvg-Team Tip: We use a battery screw driver to brake in the differential gear to get a smooth running before mounting. |
|
Place
a brass washer onto each drive
shaft, afterwards inserted a drive pin followed by the rim adapters. Fixe each adapter with a washer and a nut. (see pictures) |
 |
 |
 |
 |
Insert
two self tapping screws into the
open holes on each side of the differential housing. |
|
Insert
the adapter caps into the adapters.
Align tires in pairs and mount them with the provided hexagonal screws |
 |
 |
And
to the end of the assembly in such
a way it should look like this. |
|
And
now wish you a lot of fun with the further Your hvg-Team!! |
|
